Connect devices, buildings, and legacy systems without a rip-and-replace.
Most IoT projects fail at the seams — a sensor that speaks Modbus, a building management system that only understands BACnet, and a cloud platform that expects clean JSON over MQTT. We design and build the gateway and protocol layer that connects them, so existing equipment and new devices can share one coherent data picture without forcing you to rip out working infrastructure.
Discuss Your ProjectMQTT, BACnet, KNX, Modbus, and Zigbee translated into one consistent data model.
Legacy building management and industrial equipment integrated as-is, not replaced.
Network segmentation and authenticated gateways so legacy protocols never expose a raw attack surface.
Inventory existing devices, protocols, and building or industrial systems in play.
Gateway architecture, protocol mapping, and unified data schema.
Build and deploy gateways, validate against real devices before wide rollout.
Harden network segmentation, then extend the pattern to additional sites or device types.
IoT & Embedded Systems
Reliable, low-power firmware for the devices your product depends on.
IoT & Embedded Systems
Turn raw device telemetry into dashboards people actually check.
IoT & Embedded Systems
Automate lighting, HVAC, and energy management from a single connected system.
Common questions about our IoT Integration Consulting service.
We integrate with it rather than replacing it. Most commercial BMS platforms expose BACnet or a vendor API, which our gateway layer translates into modern protocols for downstream analytics — the existing BMS keeps running exactly as it does today.
It depends on range, power budget, and data volume: Zigbee or Thread for battery-powered sensor meshes, MQTT over Wi-Fi or cellular for higher-bandwidth devices, and BACnet/KNX/Modbus when integrating with existing building or industrial equipment. We assess this case by case rather than defaulting to one stack.
Yes — Modbus TCP and RTU integration is one of our most common engagements, particularly for manufacturing clients connecting legacy PLCs and equipment into a modern data platform.
Network segmentation is non-negotiable — OT devices sit behind a dedicated gateway with strict firewall rules, and only sanitised, authenticated data crosses into the IT/cloud side. We never expose legacy protocols like Modbus or BACnet directly to the internet.
Both — we can specify and deploy gateway hardware (typically industrial PCs or purpose-built IoT gateways) or run our integration software on infrastructure you already operate, depending on your existing estate.
A single-protocol bridge for a well-documented system can be running in 4-6 weeks. Multi-site or multi-protocol integrations, especially involving legacy BMS or SCADA with limited documentation, typically run 3-4 months.
Our team will scope your requirements and come back with a clear proposal within 48 hours.